IC Knowledge Base

Manually moving a cisco SPA5xx handset from the ipvs platform to the IC-Talk3 service

Manually remove phone from legacy IPVS service
Manually remove the device from the IPVS legacy service (remove the device from the associated user, then using device manager delete the device).
 
Locally repower handset
unplug the device for 15 minutes and then plug back in
 
Locally factory reset the handset
Perform the following on the handset locally:
1. On the handset itself, press the Setup button. 
2. Scroll down to Factory Reset using the Navigation button. 
3. Press the OK soft key afterwards. SPA will reboot and will be back to its default settings.

Point the phones to the new IC-Talk3 service:
1. Connect the phone as required and power on.
2. Press the Setup button.
3. Down arrow to Network and select. (if configuring the 525g then down arrow to 9 Status)
4. Option 2 shows the Current IP Address
5. Enter this IP address into your Internet browser on a PC that is connected to the same LAN (you may need to connect a computer to the same switch as the phone for this procedure)
6. A page similar to the below should be displayed:
 
 
7. Click the Admin link in the top right hand corner of the page.
8. Click the Advanced link in the top right hand corner of the page.
9. Click the Provisioning tab.
 
10. Replace the contents of the field Profile Rule with the following:
- Cisco 50xG & 52xG Series -  https://dm-linksys.yourwhc.co.uk/dms/phone/$MA.xml
- Cisco 51x Series -  https://dm-csb.yourwhc.co.uk/dms/phone/$MA.xml
11. Click Submit All Changes button at the bottom of the page
 
Reboot the handset
1. On the handset itself, press the Setup  button.
2. Scroll down to Reboot using the Navigation  button.
3. Press the OK soft key afterwards. SPA will reboot and will be back to its default settings.
 
Locally Repower the handset
When the handset has rebooted please repower the handset again.
note: When the handset has been repowered it may well go through a number of reboots / upgrade / resets before the handset configuration is complete.
0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
SIP Response Codes
Viewed 219 times since Mon, May 13, 2019
Wireshark tracing for fault finding
Viewed 319 times since Mon, May 13, 2019
ictalk3 Common Questions / FAQs
Viewed 192 times since Mon, May 13, 2019
Firewall & Security Guide
Viewed 324 times since Mon, Jun 17, 2019
Guide for customers migrating from IPVS to IC-talk3
Viewed 236 times since Mon, Sep 9, 2019
Internet Central Limited, Innovation Centre, Keele Science Park, Keele, Staffordshire ST5 5NB
Registered Office: Ivy House Foundry, Hanley, Stoke-on-Trent, ST1 3NR
Registered in England: Reg No. 03079542 VAT Reg No. GB 278 923 705
Contact Us |Terms & Conditions |Legal, Privacy and Cookies
All prices exclude VAT E.&O.E © 2015 Internet Central

All trademarks and logos appearing on the site are the property of their respective owners