IC Knowledge Base

Draytek IC-air configuration

Before you start to configure the router. Please see the Article "How to locate your configuration sheet". Once you have read and followed the steps in that article, you can proceed to configure your router.


  1. Log into the device via IP using these details ;username = admin  Password = admin
  2. Once logged in, select Internet access in WAN, change the access mode to PPPOE and then select details page


  3. Once you're in details page, enable the connection, put in your own customer username and password (if you do not have these and cannot find them from the how to locate your configuration sheet, contact support).



 Once this is completed, you should gain internet access, if you wish to configure your WIFI go to the below.

Within General setup you can change the SSID, and within security you can change the password for the WIFI.


You have now completed the steps to configuring your router. 

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Security Code Security Code
Related Articles RSS Feed
Draytek firmware upgrade
Viewed 1248 times since Tue, May 22, 2018
Security Advisory: Vigor 3900, 2960, 300B Router Vulnerability (July 2020)
Viewed 372 times since Wed, Jul 29, 2020
Internet Central Limited, Innovation Centre, Keele Science Park, Keele, Staffordshire ST5 5NB
Registered Office: Ivy House Foundry, Hanley, Stoke-on-Trent, ST1 3NR
Registered in England: Reg No. 03079542 VAT Reg No. GB 278 923 705
Contact Us |Terms & Conditions |Legal, Privacy and Cookies
All prices exclude VAT E.&O.E © 2015 Internet Central

All trademarks and logos appearing on the site are the property of their respective owners